当前位置：首页> 继电器参数详解

继电器参数详解

时间：2024-03-11 04:10:38 下载该word文档

Electronic

1. 安全認證: Safety Standard:
2. 接點規格: Contact Specification:
2.1 接點間隙: Contact Gap:
2.2 接點阻抗: Contact Resistance
2.3 接點容量: Contact Capacity:
3. 攝氏20度之線圈規格: Coil Specification at 20 °C:
3.1 額定電壓: Rated Voltage:
3.2 額定電流: Nominal Current:
3.3 額定消耗功率: Rated Power Consumption:
3.4 感動電壓: Pull In Voltage:
3.5 開放電壓: Drop Out Voltage:
3.6 最大應加電壓: Max. Allowable Voltage:
3.7 線圈阻抗: Coil Resistance:
3.8 動作時間: Operate Time:
3.9 開放時間
Release Time: TI03011, V.02
Page: 1 C-UL, E333244
TUV,R50165834 CQC，CQC10002042508

最小0.40 mm。 0.40 mm Minimum.
初始值最大100mΩ；
流通電流1A、開路測試電壓: 6VDC；使用電壓下降法量測。
Maximum 100mΩ at initial value. Test Current: 1A, Open Circuit Test Voltage: 6VDC. By using Voltage Drop Method.
250VAC Cosφ=1，可通過電流為8安培。 8 Amps at 250VAC Cosφ=1.

12VDC.
33.3 mA ± 10% at 50 Hz.
0.4 W ± 10%.
≦ DC 9.60V (當電壓漸漸施加於繼電器時接點之動作電壓，為額定電壓之80% ≦ DC 9.60V (Contact operating voltage when voltage is gradually applied. It is 80% of the Rated Voltage
≧ DC 1.20V (當額定電壓漸漸的減少時接點放開之電壓，為額定電壓之10% ≧ DC 1.20V (Contact breaking voltage when rated voltage is gradually reduced. It is 10% of the Rated Voltage
DC 15.60V (為額定電壓之130% DC 15.60V (130% of the Rated Voltage
360 Ω ± 10%.
在施加定額電壓時最大為12 milliseconds。
12 milliseconds Maximum when rated Voltage is applied.
在定額電壓突然消失時最大為8 milliseconds.。
8 milliseconds Maximum when rated Voltage is suddenly cut off.

Electronic

3.10 線圈溫升: Coil Temperature Rise:
4. 電氣特性: Electrical Characteristics:

4.1 使用壽命: Life Expectancy:
4.1.1 電氣壽命: Electrical Life:

4.1.2 機械壽命: Mechanical Life:
4.1.3 最大操作頻率
Maximum Operating Frequency:
4.2 絕緣耐壓: Dielectric Strength:
4.2.1 接點對接點間: Between Contacts:
4.2.2 線圈對接點間: Between Coil & Contact:
4.3 絕緣阻抗: Insulation Resistance:
4.4 震動測試: Vibration
TI03011, V.02
Page: 2
在空載時線圈施加最大可允許電壓，待溫度穩定後量測的溫度不可超過30 °C。(不包含環境溫度 30 °C Maximum. Maximum Allowable Voltage is applied to Coil while no load should be applied to Contacts, then the temperature should be measured when the value is stabilized. Environment temperature should not be included in.

8A/250VAC Cosφ=1，施加額定電壓時，有100,000次以上之電氣壽命。 100,000 operations Minimum. 8A/250VAC Cosφ=1 Rated Voltage is applied.
在無負載的情況下有10,000,000次以上之機械壽命。 10,000,000 operations Minimum at No Load condition.
電氣: 每分鐘30次。機械: 每分鐘300次。
Electrical: 30 operations/minute. Mechanical: 300 operations/minute.

1,000VAC，50/60 Hz，漏電流小於5mA，持續一分鐘。

1,000VAC at Test Frequency 50/60 Hz, Leakage Current: 5mA for 1 minute.
5,000VAC，50/60 Hz，漏電流小於5mA，持續一分鐘。
5,000VAC at Test Frequency 50/60 Hz, Leakage Current: 5mA for 1 minute.
在施加500VDC絕緣阻抗之量測值需≧100 MΩ。 ≧100 MΩ Minimum.
A Voltage of 500VDC should be applied after which measurement shall be made.

阅读全文